Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
I have Knoppix installed on my hard disc (distro 7.0.2, kernel release 3.3.7.).
Could you please tell me if ALL scripts in the directory /etc/init.d/ are
executed at boot time?
The reason I ask is because I have altered (intelligently) one or two of the
standard scripts that are in /etc/init.d/, such as
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig.
But before I altered them, I kept a copy of the originals in /etc/init.d/, and
in the above case the copies I kept are
/etc/init.d/knoppix-startx-ORIG
/etc/init.d/knoppix-autoconfig-ORIG.
Does this mean that these latter scripts are actually being run at boot time
AS WELL AS
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig?
The system seems to run fine, but it's only just occurred to me (after a couple
of years of use), that I might be running 2 lots of scripts as above.
Your advice would be much appreciated, thanks.
Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
No, Knoppix doesn't take care of '/etc/init.d/knoppix-startx-ORIG' and '/etc/init.d/knoppix-autoconfig-ORIG'.
Have a look at '/etc/inittab'.
Many thanks Werner. Your kind reply is most welcome. I can breathe a sigh of relief that I haven't made a blunder.
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco WS-C3750-48PS-S 48-Port Managed Gigabit Switch
$45.00
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$419.99
Pakedge SE-18 Unmanaged 16-Port Ethernet Switch With 2-SFP Ports
$54.99
New Linksys SE3005 5-port Gigabit Ethernet Switch
$15.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$18.99
NETGEAR 5-Port Gigabit Ethernet Unmanaged Switch (GS305) - NEW IN BOX
$18.99
Cisco WS-C3750X-48T-S 48 Port 3750X Gigabit Switch - Same Day Shipping
$49.99
*NETGEAR PROSAFE (JGS524V2) 24-Port Gigabit Ethernet Switch *NO AC*
$29.99
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$143.32