Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
I have Knoppix installed on my hard disc (distro 7.0.2, kernel release 3.3.7.).
Could you please tell me if ALL scripts in the directory /etc/init.d/ are
executed at boot time?
The reason I ask is because I have altered (intelligently) one or two of the
standard scripts that are in /etc/init.d/, such as
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig.
But before I altered them, I kept a copy of the originals in /etc/init.d/, and
in the above case the copies I kept are
/etc/init.d/knoppix-startx-ORIG
/etc/init.d/knoppix-autoconfig-ORIG.
Does this mean that these latter scripts are actually being run at boot time
AS WELL AS
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig?
The system seems to run fine, but it's only just occurred to me (after a couple
of years of use), that I might be running 2 lots of scripts as above.
Your advice would be much appreciated, thanks.
Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
No, Knoppix doesn't take care of '/etc/init.d/knoppix-startx-ORIG' and '/etc/init.d/knoppix-autoconfig-ORIG'.
Have a look at '/etc/inittab'.
Many thanks Werner. Your kind reply is most welcome. I can breathe a sigh of relief that I haven't made a blunder.
Juniper EX4200-48PX 48-Port PoE+ Switch 10/100/1000BaseT
$180.00
JUNIPER NETWORKS Qfx5100-48s-afi 48Port 10 Gigabit Ethernet Switch *WORKING*NC
$1599.99
JUNIPER EX3300-24T - 24-Port 1Gb + 4-Port SFP 10Gb Ethernet Switch - Tested
$145.00
Juniper EX2300-24P Rack Mountable Ethernet Switch
$550.00
JUNIPER NETWORKS EX2200-48P-4G PoE 48 port network Gigabit switch
$68.00
Juniper EX3300-24P 24 Port Switch
$160.00
JUNIPER QFX5100-48S-AFI SWITCH 48 SFP+ 6QSFP 2xPSUs TESTED AND WORKING
$1599.99
Juniper Networks EX2300-48P 48 Port PoE 4 SFP 1/10G Network Switch
$739.00
Juniper Networks EX4300-48P 48Port GbE PoE+ Switch 1000Base-T EX 4300 48P
$243.00
Juniper Networks EX3300-24P 24 Port Gigabit PoE 4 SFP 1/10G Network Switch
$299.00