This may help:
http://www.boot-disk.com/boot_priority.htm
I'm using KNOPPIX_V7.7.1DVD-2016-10-22-EN.
I boot using the DVD and run Install KNOPPIX to flash disk.
When I try to boot from the USB all I get is a blinking cursor...
I have a Active@Boot USB that works in the computer I'm using.
I do notice that my boot menu shows the Knoppix USB as 'USB-ZIP0 : SanDisk' under the 'Removable' section of the menu.
When I boot from my Active@Boot USB the boot menu show it as 'USB-HHD0 : USB DISK' under the 'Hard Disk' section of the menu.
Any help would be appreciated... where do I start to make this work
This may help:
http://www.boot-disk.com/boot_priority.htm
Thanks for the reply... I did check all the BIOS settings but, after using the same USB on some other computers, it seems to be something unique to the way some BIOS's treat the device descriptor.
I'm puzzled why one machine will see it as USB-ZIP0 and others as USB-HHD0. I'm going to look at the disk type byte(s) and see what (if any) difference there is between the boot-able USB created by Active@Boot and the one created by flash-knoppix. Can anyone point me to where the disk type byte(s) may (or what they should) be?
Another thing I'm going to do is create the USB on a machine that does see it as USB-HDD0...
Brand New Amiga 4000T Keyboard
$299.99
Commodore Amiga A2386SX Bridge board
$900.00
Mini External OLED AMIGA Gotek Floppy Drive Emulator For Amiga 500/500+/600/1200
$40.47
$299.95
Amiga Hard Disk Controller A2500 DAMAGED PINS
$90.00
Commodore Amiga 1060 Side Car Expansion "IBM PC EMULATOR" VERY RARE COLLECTIBLE
$1499.95
$49.99
Commodore Amiga A2000 Mimetics Frame Buffer card
$200.00
AMIGA 500 COMPUTER COMMODORE Complete in Box Powers/untested Good Condition
$370.00
pi1541 Disk Emulator for Commodore -
$38.95