Hello,
In syslinux.cfg I added the bolded lines:
LABEL auto
SERIAL 0
CONSOLE 0
SAY Booting via ttyS0
TIMEOUT 100
KERNEL linux
APPEND lang=en apm=power-off initrd=minirt.gz nomce hpsa.hpsa_allow_any=1 loglevel=1
In the RS232 terminal, 3 lines are printed but rest of messages are all displayed on the VGA display.
What am I doing wrong ?
There are no cheat codes for this purpose.
Thank you,
Zvika
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP Transceiver Module
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
10Gtek ASF-10G-T 10GBase-T 10GbE SFP+ to RJ-45 Copper Optical Transceiver Module
$35.99
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95