Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
I have Knoppix installed on my hard disc (distro 7.0.2, kernel release 3.3.7.).
Could you please tell me if ALL scripts in the directory /etc/init.d/ are
executed at boot time?
The reason I ask is because I have altered (intelligently) one or two of the
standard scripts that are in /etc/init.d/, such as
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig.
But before I altered them, I kept a copy of the originals in /etc/init.d/, and
in the above case the copies I kept are
/etc/init.d/knoppix-startx-ORIG
/etc/init.d/knoppix-autoconfig-ORIG.
Does this mean that these latter scripts are actually being run at boot time
AS WELL AS
/etc/init.d/knoppix-startx
/etc/init.d/knoppix-autoconfig?
The system seems to run fine, but it's only just occurred to me (after a couple
of years of use), that I might be running 2 lots of scripts as above.
Your advice would be much appreciated, thanks.
Why bother and not keep Knoppix simple and leave it as it is DESIGNED to be used?
No, Knoppix doesn't take care of '/etc/init.d/knoppix-startx-ORIG' and '/etc/init.d/knoppix-autoconfig-ORIG'.
Have a look at '/etc/inittab'.
Many thanks Werner. Your kind reply is most welcome. I can breathe a sigh of relief that I haven't made a blunder.
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$249.99
SuperMicro 2-Port SFP+ 10Gbps Super I/O Module w/ Bracket AOC-MTGN-I2S
$62.99
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
F5 Networks 10GB OPT-0016-00 F5-UPG-SFP+-R 10GBASE/SR SFP Transceiver
$4.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Mellanox Original MFM1T02A-SR 10GbE 10GBASE-SR SFP+ Transceiver
$9.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
Cisco 10G SFP+ Module SFP-10G-SR 10-2415-03 (Lot of 5)
$24.99