Hello,
In syslinux.cfg I added the bolded lines:
LABEL auto
SERIAL 0
CONSOLE 0
SAY Booting via ttyS0
TIMEOUT 100
KERNEL linux
APPEND lang=en apm=power-off initrd=minirt.gz nomce hpsa.hpsa_allow_any=1 loglevel=1
In the RS232 terminal, 3 lines are printed but rest of messages are all displayed on the VGA display.
What am I doing wrong ?
There are no cheat codes for this purpose.
Thank you,
Zvika
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
$500.00
Altair MITS 8800 CPU Card 8080A S-100 S100 replica IMSAI CP/M
$35.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00