Hello,
In syslinux.cfg I added the bolded lines:
LABEL auto
SERIAL 0
CONSOLE 0
SAY Booting via ttyS0
TIMEOUT 100
KERNEL linux
APPEND lang=en apm=power-off initrd=minirt.gz nomce hpsa.hpsa_allow_any=1 loglevel=1
In the RS232 terminal, 3 lines are printed but rest of messages are all displayed on the VGA display.
What am I doing wrong ?
There are no cheat codes for this purpose.
Thank you,
Zvika
SanDisk 128GB Ultra Dual Drive USB Type-C, USB 3.1 Flash Drive - SDDDC2-032G-G46
$10.99
SanDisk 256GB Ultra USB 3.0 Flash Drive - SDCZ48-256G-U46
$19.99
SanDisk 32GB Ultra Drive Dual Go USB Type-C Flash Drive, Green - SDDDC3-032G-G46
$8.99
SanDisk 128GB Ultra USB Type-C Flash Drive - SDCZ460-128G-G46
$13.99
Sandisk 16GB 32GB 64GB 128GB Cruzer Blade Flash Drive Memory Stick USB Lot Pack
$4.99
64GB USB 3.0 Flash Drive USB Memory Stick High Speed Retractable USB Thumb Drive
$5.99
Type C USB 3.0 Flash Drive Thumb Drive Memory Stick for PC Laptop 512GB 1TB 2TB
$10.30
2TB USB 3.0 Flash Drive Thumb U Disk Memory Stick Pen PC Laptop Storage New
$10.79
LOT 32GB 64GB 128GB USB 3.0 Flash Drive Memory Stick Retractable Thumb Drive
$420.99
USB 3.0 Flash Drive 32GB 64GB 128GB Memory Stick Thumb Stick Lot Pack
$353.99