Hello,
In syslinux.cfg I added the bolded lines:
LABEL auto
SERIAL 0
CONSOLE 0
SAY Booting via ttyS0
TIMEOUT 100
KERNEL linux
APPEND lang=en apm=power-off initrd=minirt.gz nomce hpsa.hpsa_allow_any=1 loglevel=1
In the RS232 terminal, 3 lines are printed but rest of messages are all displayed on the VGA display.
What am I doing wrong ?
There are no cheat codes for this purpose.
Thank you,
Zvika
Cisco ASA 5520 Adaptive Security Appliance
$56.75
Check Point L-71 6 Port Gigabit Enterprise Firewall
$34.99
Fortinet FortiGate-40C Network Security Firewall
$42.50
Fortinet Fortigate FG-61E | Firewall Network Security Appliance
$49.99
Fortinet FortiGate FG-40F Network Security Firewall
$100.00
Dell SonicWall TZ300 5-Port Network Security Firewall Appliance APL28-0B4
$24.95
OPNsense six-port Gigabit router/firewall on Lanner FW-7535 hardware
$69.00
Palo Alto PA-220 Next-Gen Firewall 520-000309-00J w/ Power adapter
$69.98
Fortinet Fortiwifi 60D FG-60D Security Appliance Firewall / VPN w/ AC Adapter
$999.97
Dell SonicWALL TZ300 | Firewall Security Appliance
$24.99