Hello,
In syslinux.cfg I added the bolded lines:
LABEL auto
SERIAL 0
CONSOLE 0
SAY Booting via ttyS0
TIMEOUT 100
KERNEL linux
APPEND lang=en apm=power-off initrd=minirt.gz nomce hpsa.hpsa_allow_any=1 loglevel=1
In the RS232 terminal, 3 lines are printed but rest of messages are all displayed on the VGA display.
What am I doing wrong ?
There are no cheat codes for this purpose.
Thank you,
Zvika
Vintage Commodore Amiga 1000 Keyboard & Mouse - Untested - As Is - No Computer
$249.00
Amiga KPR-E94YC Commodore Keyboard Untested
$150.00
Mini External OLED AMIGA Gotek Floppy Drive Emulator For Amiga 500/500+/600/1200
$40.44
Commodore Amiga 1060 Side Car Expansion "IBM PC EMULATOR" VERY RARE COLLECTIBLE
$1499.95
GVP Phone PAK VFX for Amiga 2000 or 3000 USA Made VERY RARE COLLECTIBLE
$199.95
Apollo Vampire 600v2 / 600 V2 FPGA Accelerator Card for Commodore Amiga 600
$350.00
Commodore Amiga BSC Tandem Install on Floppy Disk Buroautomation AG
$12.95
v4.5 EPROM BOOT Chip for GVP Accelerators & SCSI Controllers for Amiga 500 2000
$9.98
pi1541 Disk Emulator for Commodore -
$38.95
AMIGA 500 COMPUTER COMMODORE Complete in Box Powers/untested Good Condition
$370.00