Try this:
pump -i eth0
Is it possible to invoke dhcp with an argument to ifconfig like:
ifconfig eth0 dhcp
or is it possible to have netcardconfig automatically invoke dhcp broadcast without promting for it?
what I,m trying to do is append a couple of commands to knoppix.sh on my hard drive so that my network card will work.
right now I have:
modprobe 8139too
netcardconfig
Netcard config prompts for dhcp broadcast (yes). I want to just type
knoppix myconfig=scan
and have everything ready after initializations.
Try this:
pump -i eth0
Does the trick, thanks
Wonderful! This is the exact same situation I am in, and was looking for a cure for.Originally Posted by aay
Right now I'm using CAT5 into my internal nic on my laptop.
If I want to take down dhcp, do I do the following?
I tried it and it did not work.Code:pump -i eth0 ifdown
thanks
Try ifdown eth0.Originally Posted by JockVSJock
Tried that...didn't workOriginally Posted by Stephen
See output below...
Code:root@Probot:~# ifdown eth0 ifdown: interface eth0 not configured
Dell PowerEdge R720 Server - 2x8c CPU,256Gb RAM, 128Gb SSD/3x900Gb SAS, Proxmox
$340.00
Supermicro 4U 36 Bay Storage Server 2.4Ghz 8-C 128GB 1x1280W Rails TrueNAS ZFS
$712.98
DELL PowerEdge R730XD 24x 2.5" Server Dual 750W Dual Heatsink - BareBones TESTED
$269.99
HP ProLiant DL360 G9 Server 2x E5-2660v3 2.60Ghz 20-Core 96GB P440ar
$304.35
Dell PowerEdge R620 Server 2x E5-2660 v1 2.2GHz 16 Cores 256GB RAM 2x 300GB HDD
$79.19
Dell PowerEdge R730XD 28 Core Server 2X Xeon E5-2680 V4 H730 128GB RAM No HDD
$389.99
Dell PowerEdge R720XD Xeon E5-2680 V2 2.8GHz 20 Cores 256GB RAM 12x4TB
$510.00
DELL POWEREDGE T430 SERVER W/ DUAL XEON E5-2609 CPU & 16GB MEMORY
$329.00
DELL PowerEdge R730 Server 2x E5-2690v3 2.6GHz =24 Cores 32GB H730 4xRJ45
$274.00
Dell PowerEdge R620 Server 2x E5-2650 V2 = 16 Cores H710P 128GB RAM 2x 600GB SAS
$274.99