Try this:
pump -i eth0
Is it possible to invoke dhcp with an argument to ifconfig like:
ifconfig eth0 dhcp
or is it possible to have netcardconfig automatically invoke dhcp broadcast without promting for it?
what I,m trying to do is append a couple of commands to knoppix.sh on my hard drive so that my network card will work.
right now I have:
modprobe 8139too
netcardconfig
Netcard config prompts for dhcp broadcast (yes). I want to just type
knoppix myconfig=scan
and have everything ready after initializations.
Try this:
pump -i eth0
Does the trick, thanks
Wonderful! This is the exact same situation I am in, and was looking for a cure for.Originally Posted by aay
Right now I'm using CAT5 into my internal nic on my laptop.
If I want to take down dhcp, do I do the following?
I tried it and it did not work.Code:pump -i eth0 ifdown
thanks
Try ifdown eth0.Originally Posted by JockVSJock
Tried that...didn't workOriginally Posted by Stephen
See output below...
Code:root@Probot:~# ifdown eth0 ifdown: interface eth0 not configured
Broadcom LSI 9400-16i Raid card SAS/SATA/NVME SFF-8643 SAS3416 PCIe 3.1 x8 HBA
$155.27
Broadcom 9560-16I RAID Card SAS/SATA/NVME 8G cache SAS3916 PCIe 4.0 SFF8654
$727.00
Oracle 7085209 LSI MegaRAID SAS 9361-8i 1GB Cache 12Gbps SAS/SATA PCIe RAID Card
$28.20
Adaptec ASR-81605ZQ 12G SAS 16-Port 1GB Cache PCIe x8 RAID Controller
$131.99
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile IT MODE
$15.98
LSI MegaRAID 9361-8i 12Gb PCIe 8-Port SAS/SATA RAID 1Gb w/BBU/CacheVault/License
$39.95
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$82.49
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$58.99
NEW LSI MEGARAID SAS 9361-8i 12GB/s SAS + SATA RAID CONTROLLER CARD PCIe x8 3.0
$99.00