Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
ππ₯οΈ Vintage Apple III Computer - Works Great Monitor, Hard Drive, Software π
$2000.00
MacEffects Gray ALPS Mechanical Keyboard for Vintage Apple IIe Computers
$195.00
VINTAGE Apple Macintosh LC (FOR PARTS - DOES NOT BOOT) NO HDD #27
$49.99
Vintage Apple Macintosh Extended Keyboard II AEK M3501 + ADB Mouse M2706 TESTED
$99.00
Vintage Apple Macintosh IIsi M0360 Computer For Parts or Repair w/Power Cord
$69.99
Vintage 1990 Apple Keyboard II M0487
$49.99
Vintage Apple Ethernet Twisted-Pair Transceiver Model M0437
$19.99
Vintage Apple Macintosh SE Case - Empty Shell - Housing retro project
$60.00
Vintage Apple Newton MessagePad 2000 With Original Box and Some Accessories
$169.99
Apple Macintosh Performa 466 Vintage Computer | SKU 146754
$149.95