Hello,
In syslinux.cfg I added the bolded lines:
LABEL auto
SERIAL 0
CONSOLE 0
SAY Booting via ttyS0
TIMEOUT 100
KERNEL linux
APPEND lang=en apm=power-off initrd=minirt.gz nomce hpsa.hpsa_allow_any=1 loglevel=1
In the RS232 terminal, 3 lines are printed but rest of messages are all displayed on the VGA display.
What am I doing wrong ?
There are no cheat codes for this purpose.
Thank you,
Zvika
Cisco QSFP-100G-LR4-S 100GBASE-LR4 QSFP28, 1310nm, 10km, LC, SMF
$335.99
Cisco Nexus (N2K-C2232PP) 32-Ports Rack-Mountable Expansion module -
$62.99
Cisco GLC-GE-100FX 100BASE-FX SGMII SFP, 1310nm, 2km, LC, MMF
$83.99
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco Nexus N9K-C93180YC-EX 48-Port 1/10/25G SFP + 6 40G/100G QSFP28 Switch
$789.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco C9300-48 48 Port Switch Dual PSU W/C9300-NM-8X P/N: C9300-48U-A Tested
$799.99
Cisco N5K-C5010P-BF 20-Port Nexus 5010 Series 10GbE Gigabit Ethernet Switch
$119.99