Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
TP-Link 16-Port Gigabit Ethernet Unmanaged Switch | Plug and Play | TL-SG1016D
$39.99
Loocam Gigabit PoE Switch 8 Port 96W 2 Uplink Port Unmanaged Ethernet Switch
$49.99
Tenda 8/5 Port Gigabit Ethernet Splitter Network Switch SG108 / SG105 Unmanaged
$19.99
TP-Link TL-SG108PE | 8 Port Gigabit PoE Switch | Easy Smart Managed | 4 PoE
$44.99
Tenda SG108 Network Gigabit Switch 8 Port 10/100/1000Mbps Wired Ethernet Lan Hub
$19.99
Tenda SG105 5-Port 10/100/1000Mbps Gigabit Desktop Switch Ethernet Splitter Hub
$13.99
Brocade FCX648S-HPOE 48 Port Gigabit PoE Network Switch - SAME DAY SHIPPING
$54.95
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
Cisco Catalyst WS-C3650-48FS-E 48-Port Full PoE Switch (Refurbished)
$165.00
Cisco WS-C2960S-48FPS-L Catalyst 2960-S 48-Port PoE+ Network Switch
$174.99