Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Fanxiang SSD 4TB 2TB 1TB PS5 SSD M.2 NVME SSD 7300MBS PCIe 4.0 Solid State Drive
$269.99
Fanxiang 4TB 2TB 1TB SSD 550MB/s 2.5'' SATA III Internal Solid State Drive lot
$188.99
Kingshark M.2 2242 2280 SSD 128GB 256GB 512GB 1TB Internal Solid State Drive Lot
$179.99
SAMSUNG 2.5 in SSD 870 EVO 2TB 1TB 500 GB 250 GB SATA III Solid State Drive lot
$149.13
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$19.99
Patriot P300 128G 256GB 512GB 1TB 2TB M.2 2280 PCIe Gen3x4 NVMe Internal SSD Lot
$16.99
WD BLUE 3D NAND 250GB 2.5" SATA Laptop SSD Solid State Tested,Wiped -WDS250G2B0A
$16.00
1080PRO 4TB SSD Solid State Hard Drive Ngff M.2 SSD Gaming Internal Hard Disk
$28.99
Fanxiang M.2 SATA SSD 2TB 1TB 512GB 256GB SSD Internal M2 Solid State Drive Lot
$109.99
Fanxiang SSD 4TB 2TB 1TB 512GB SATA SSD 2.5'' III Internal Solid State Drive lot
$113.99