Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Juniper Networks EX2300-48P 48 Port Gigabit PoE 4 SFP 1/10G Network Switch
$185.00
Juniper Networks EX2300-C-12T Compact 12-Port EX2300-C Series Ethernet Switch
$300.00
Juniper Networks EX2200-C-12P-2G Gigabit Ethernet Managed Switch
$79.99
Juniper EX4300-48P 48-Port PoE Rack Mountable Ethernet Switch + Rack Ears 2
$149.98
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
Juniper Networks EX2200-C Ethernet Managed Switch w/ Rack Mounts
$74.99
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$59.95
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$30.00
Juniper Networks EX3300 EX3300-48P PoE+ 48-Port 4x SFP Gigabyte Ethernet Switch
$59.99
Juniper Networks SRX220 8-Port Gigabit Services Gateway Security Appliance
$45.00