Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
MITS ALTAIR 8800 Vintage Computer w/ Keyboard, Floppy, boards - Buy It Now
$9275.00
MITS ALTAIR 8800 B Original Vintage Microcomputer
$5250.00
Altair 8800 CPU Board Working *TESTED* reproduction
$790.00
CROMEMCO 64KZ, 64K Memory board S-100 board 1978 used for Imsai, or Altair
$185.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$8900.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$69.95
IMSAI 8080A MPU-A CPU Parts Kit Not Altair MITS (board NOT included)
$59.95
New Unused S-100 Bus Edge Card Connector / Old Vintage Altair Imsai Computer
$9.99
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$358.99
Wenger laptop backpack, Altair, 15.6 inch, tablet compartment, Black
$145.19