Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Fanxiang 4TB 2TB 1TB SSD 550MB/s 2.5'' SATA III Internal Solid State Drive lot
$188.99
Netac 2TB 1TB 512GB 240GB Internal SSD 2.5'' SATAIII 6Gb/s Solid State Drive lot
$118.99
Fanxiang SSD 4TB 2TB 1TB 512GB SATA SSD 2.5'' III Internal Solid State Drive lot
$108.29
Fanxiang 2TB 1TB 512GB 550MB/S MSATA SSD Solid State Drive 6Gb/s PC/Laptop lot
$104.49
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$13.99
WD BLUE 3D NAND 250GB 2.5" SATA Laptop SSD Solid State Tested,Wiped -WDS250G2B0A
$16.99
Crucial M500 480GB SED MLC 2.5" 6Gbps SATA Drive CT480M500SSD1 - PRICE PER UNIT
$24.99
Fanxiang M.2 SATA SSD 2TB 1TB 512GB 256GB SSD Internal M2 Solid State Drive Lot
$21.99
Netac 1TB 2TB 512GB Internal SSD 2.5'' SATA III 6Gb/s Solid State Drive lot
$119.99
Fanxiang 2TB 1TB External SSD USB 3.2 4TB Portable Solid State Hard Drive LOT
$249.99