Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Vintage Apple Design Keyboard M29080 And Mouse M2706 ADB Mac 1995 Tested Working
$54.96
Vintage Apple Macintosh SE M5010 Computer w/ Keyboard & mouse -power up- no OS
$139.99
Vintage Apple Macintosh 512K / Mouse, Keyboard & Extras + Carry Case / Turns On
$260.00
Vintage Apple A2M2010 Monitor II, Green Phosper CRT
$99.99
Vintage Classic Apple Macintosh System Boot Install Disk Floppy/CD *Pick Version
$10.39
Vintage Apple 3.5" Drive Floppy Disk Drive A9M0106 - Untested
$69.99
Vintage Apple Macintosh KB-405 AEK 405 Extended Keyboard - Untested
$39.99
Vintage Apple Mac M0116 Keyboard salmon Alps switches, no ADB cable, bad T key
$50.00
Vintage Apple iMac G3 Blue Blueberry M5521 450MHZ 20GB 128MB Ram Tested Working
$249.87
Vintage Apple IIe 2e iie Computer A2S2064
$215.00