Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
HYNIX HMT31GR7BFR4C-H9 8GB PC3-10600R DDR3-1333MHZ 2Rx4 (LOT OF 8) DRAT-3
$999.00
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Crucial 8GB 1x8GB PC RAM PC3L 12800U DDR3 1600MHz Desktop Memory DIMM
$8.99
Micron 8GB DDR4 1Rx16 PC4-3200AA Laptop RAM Memory MTA4ATF1G64HZ-3G2E2
$10.00
Team T-FORCE VULCAN Z 32GB (2 x 16GB) PC RAM DDR4 3200 (PC4 25600) Memory
$54.99
SK Hynix 8GB DDR4 1Rx16 -PC4-3200AA/ HMAA1GS6CJR6N-XN SODIMM
$10.00
SK Hynix 8GB (1X8GB) RAM PC4-19200 DDR4-2400T Desktop SDRAM HMA81GU6AFR8N-UH
$10.99
Micron 16GB DDR4-2400 SODIMM MTA16ATF2G64HZ-2G3E1 Laptop Memory RAM
$21.99
128GB Kit 4x 32GB PC4-17000 LRDIMM DELL POWEREDGE R730xd R730 R630 Memory RAM
$127.96
Apple MacBook Air (2020) 13.3-inch, 1.1GHz, i5, 8GB RAM, 512GB SSD, Space Gray
$299.00