Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
OEM Dell 130W HA130PM130 DA130PM130 Laptop Power Adapter Charger 4.5mm 6TTY6 XPS
$26.99
Lot of 10 Genuine Dell C9HYX AC Adapter Charger 90W LA90PM130 OEM w/ Power Cable
$109.99
OEM 130W USB-C Type-C Charger for Dell XPS 15 9500 9570 9575 17 9700 DA130PM170
$34.88
Genuine OEM 65W Dell PA-12 AC Adapter Charger For 928G4 LA65NS2-01 n4010 D531N
$13.99
Genuine OEM Dell 130W AC Adapter Charger Brick Large Tip 19.5V 6.7A
$4.97
OEM Dell Inspiron 11 13 14 15 17 3000 5000 7000 AC Adapter Charger 65W 4.5mm Tip
$10.99
OEM Dell 90W AC Adapter Charger OptiPlex 3040 7040 3060 7050 3070 3020 9020M
$14.69
OEM 45W AC Adapter Charger for Dell Inspiron 15 3551 5555 5558 5559 7558 + Cable
$12.69
LOT - 59 OEM Dell AC Adapters HA65NM130 LA65NM130 LA90PM130 LA90PM170++ *TESTED*
$385.00
Genuine 45W Power Adapter Charger for Dell DA45NM140 0KXTTW 4.5*3.0mm OEM
$16.99