Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
CISCO UCSB-B200-M5 UCS B200 M5 BLADE SERVER - CAN BUILD TO SPEC
$495.00
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$399.00
HP ProLiant BL460c Gen9 Blade 2x E5-2690v4 2.6GHz =28 Cores 32GB P246 650FLB
$223.00
DELL PowerEdge M630 Blade 2x E5-2680v4 2.4GHz =28 Cores 128GB H330 2x10Gb X520
$275.00
Dell PowerEdge M620 Blade Server 2 x Xeon e5 2665 8 x 16 GB(128) RAM - No HD
$59.99
HP ProLiant BL460c Gen9 Blade Server Intel Xeon E5-2698 v3 - 512GB RAM
$255.42
Sun Microsystems Blade 100 Workstation UltraSPARC-IIe 500MHz 256MB Server No HDD
$95.00
Dell PowerEdge M620 Blade Server 2x 10C E5-2690v2 64GB Ram 2x 600GB 10k HDD
$125.00
Dell PowerEdge M640 Barebone Server Blade No Hard Drive Trays
$499.00
HP BL460c G10 Blade 2x Gold 6140 2.3GHz =36 Cores 128GB P204i-B QMH2672 2x 20GB
$642.00