Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
ORICO 5 Bay Raid USB3.0 to SATA External Hard Drive Enclosure for 3.5'' HDD LOT
$140.79
LaCie 5BIG NETWORK 2 5-bay RAID HDD Bay [ SEE DESCRIPTION ]
$119.99
ORICO 5 Bay Raid Enclosure USB3.0 SATA External Hard Drive Enclosure Up to 80TB
$115.59
BUFFALO LinkStation Pro Quad 4-Bay RAID High Performance NAS - No HDDS
$44.99
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile
$15.98
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$54.27
Inspur LSI YZCA-00424-101 Raid Card 12Gbps HBA Controller Low Profile 9300-8i IT
$15.98
Dell PERC H330 PCIe 3.0 x8 RAID Storage Controller 4Y5H1 High Profile
$14.99
Dell H2R6M PowerEdge PERC H700 6Gb/s 512MB SAS RAID Controller
$19.99
Yottamaster 2 Bay RAID Hard Drive Enclosure USB 3.1 For 2.5" SATA HDD SSD UASP
$56.25