Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco SG300-52-Port Gigabit Managed Rack Mountable Network Switch
$44.95
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$140.23
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97
HPE ARUBA 2530-24G J9773A PoE+ 24-PORT GIGABIT ETHERNET SWITCH J9773-60201
$93.24
NETGEAR GS108 ProSafe 8-Port GbE Unmanaged Switch w/ Power Adapter
$14.99
NETGEAR GS305300PAS 5 Port Gigabit Ethernet Unmanaged Switch
$22.99
TP-Link TL-SG108 8-Port 10/100/1000 Mbps Gigabit Ethernet Desktop Switch FREE SH
$14.99
Brocade ICX 6430-24 Ethernet Switch 10/100/1000
$59.99
Loocam Gigabit PoE Switch 8 Port 96W 2 Uplink Port Unmanaged Ethernet Switch
$49.99
Cisco WS-C3750X-48PF-S 48 Port PoE Gigabit Switch w/ C3KX-NM-10G & Dual 1100WAC
$121.88