Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$140.23
Cisco SG300-52-Port Gigabit Managed Rack Mountable Network Switch
$44.95
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97
HPE ARUBA 2530-24G J9773A PoE+ 24-PORT GIGABIT ETHERNET SWITCH J9773-60201
$93.24
NETGEAR GS108 ProSafe 8-Port GbE Unmanaged Switch w/ Power Adapter
$14.99
Netgear ProSafe FS726T 24 Port 10/100 Smart Switch w/2 Gigabit Ports
$19.99
Cisco SG300-52 52 Port Gigabit Managed Network Switch w/ Rack Ears
$34.99
TP-Link TL-SG108 8-Port 10/100/1000 Mbps Gigabit Ethernet Desktop Switch FREE SH
$14.99
Netgear Prosafe 48-Port GbE & 4-Port SFP Managed Network Switch GS752TS
$59.99
Loocam Gigabit PoE Switch 8 Port 96W 2 Uplink Port Unmanaged Ethernet Switch
$49.99