Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig Copper UPOE Network Switch
$475.00
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97
Loocam Gigabit PoE Switch 8 Port 96W 2 Uplink Port Unmanaged Ethernet Switch
$49.99
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$140.23
NETGEAR GS108 ProSafe 8-Port GbE Unmanaged Switch w/ Power Adapter
$14.99
NETGEAR GS305300PAS 5 Port Gigabit Ethernet Unmanaged Switch
$22.99
NETGEAR ProSafe GS724T Rack Mountable Managed Gigabit Switch
$20.00
Netgear FS108 V2 8-Port 10/100 Fast Ethernet Network Switch - No Adapter
$15.00
Arista DCS-7050SX-64 48-Port SFP+ 4-QSFP Network Switch 2x PSU w/Ears Tested
$214.99
Netgear Prosafe 48-Port GbE & 4-Port SFP Managed Network Switch GS752TS
$59.99