Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Grandstream GS-HT802 2 Port Analog Telephone Adapter VoIP Phone & Device, Black
$32.00
Cisco CP-8851 Business VoIP UC IP Phone *NEW*
$179.99
Polycom VVX 411 IP VOIP POE Gigabit Telephone [L/N] BUSINESS OFFICE RECEPTION
$24.00
Cisco CP-7965G IP VOIP POE Gigabit Telephone [L/N] BUSINESS OFFICE RECEPTION
$20.00
Cisco CP-7945G VOIP Phone With Stand & Handset Business IP Phone 7945
$3.00
Grandstream GS-HT802 2 Port Analog Telephone Adapter VoIP Phone Device
$17.50
Cisco CP-8845-K9 5 Line IP Video Phone - Charcoal
$25.00
Cisco/Linksys SPA2102 VoIP Phone Adapter Router 2FXS (Unlocked)
$16.99
Grandstream GS-GXP2135 Enterprise Gigabit Speed 8 Lines VoIP Device IP Phone
$26.66
NEW Polycom VVX 501 VoIP IP Phone & Stand Warranty VVX411 2200-48500-019 Lync
$49.98