Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Dell X1018 X-Series Smart Managed Switches 16-Port Gigabit 2-Port SFP Switch
$42.00
NETGEAR GS108 ProSafe (GS108-400NAS) 8 Port Standalone Gigabit Ethernet Switch
$44.99
Cisco Catalyst WS-C3650-24PS-L 24-Port Gigabit Ethernet Network Switch TESTED
$49.99
Dell PowerConnect 6224 Rackmount 24-Port Gigabit Managed Ethernet Network Switch
$31.99
TP-LINK TL-SF1005D 5-Port 10/100Mbps Desktop Switch
$8.99
NETGEAR GS305E 5-Port Gigabit Ethernet SOHO Plus Switch
$5.99
CISCO WS-C2955S-12 Catalyst Switch 2955S 12-Ports 10/100 and 2-Ports 100BASE-LX
$24.95
NEW TP-Link TL-SG108PE 8-port Gigabit PoE+ Swith w/ 4-port PoE -RES LLC STORE-
$49.50
TP-Link 24-Port Gigabit Ethernet Unmanaged Switch Desktop/Rackmount TL-SG1024D
$59.49
Cisco Small business SG300-28P Managed 28 Port Gigabit Ethernet Switch
$67.95