Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Vintage 5362 IBM System/36 Mini-Computer Mainframe 5291 2, CRT Terminal DM12N501
$249.99
IBM Type 4869 External 5 1/4in Floppy Disk Drive Mainframe Collection - UNTESTED
$65.00
6 Vintage Computer Tape Reels mainframe 3200 5000 data ibm magnetic processor
$99.00
VINTAGE IBM Type 4869 External 5 1/4" ~ Floppy Disk Drive Mainframe ~
$159.99
IBM Type 4869 External 5 1/4in Floppy Disk Drive Mainframe Collection
$145.99
01KU751 IBM Z14 zSERIES MAINFRAME SUPPORT ELEMENT 15.5" DISPLAY UNIT
$225.00
Vintage Silicon Graphics SGI Indy B006 Workstation Computer
$149.95
Vintage Family owned Atari 1200xl computer sold as is tested turns on with cable
$299.99
AOC 14in Monochrome Monitor MM-413S VGA Mainframe Collection RARE 1993
$224.99
Lotus Works Vintage Software 3.5in Disks Original Seal 1990 Mainframe Collection
$431.99