Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Dell PowerEdge MX740C Blade Server CTO Chassis H730P
$349.00
Dell PowerEdge FX2S 4 Slot Blade Chassis - CMC, 2x 2400W PSU
$299.00
Dell PowerEdge M620 Blade Server 2 x Xeon e5 2665 8 x 16 GB(128) RAM - No HD
$44.99
Dell PowerEdge M620 CTO Blade Server (for M1000e or VRTX) 32GB(4x8GB RAM) No HDD
$72.16
Dell PowerEdge M620 Blade Server
$39.99
Nutanix NXS2U2NL12G500 2U Server with 2x X10DRT-P-G5-NI22 Blades USED
$349.99
HP ProLiant BL460c Gen9 Blade Server x2 Intel Xeon E5-2698 v3 - 512GB RAM
$250.69
Dell VRTX 25 Bay SFF with 4 x M630 With (2) E5-2690 V4's 32GB Ram
$999.99
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$399.00
Dell PowerEdge FC830 8-SFF 4*Xeon E5-4669v3 2.1GHz No HDD/RAM Blade Server Node
$179.99