Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
SM883 HXM7404Q 2.5 Samsung 960GB SATA6.0Gbps MZ7KH960HAJR-00005 MZ-7KH9600 SSD
$95.00
960GB Samsung M.2 PM983 SSD PCIe NVMe 22110 Solid State Drive MZ1LB960HAJQ-00007
$74.68
005051096 EMC Data Domain 400GB SATA 3Gbps 2.5" Internal SSD 118000078
$335.99
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$14.99
Netac 1TB 2TB 512GB Internal SSD 2.5'' SATA III 6Gb/s Solid State Drive lot
$13.99
Fanxiang SSD 512GB 1TB 2TB 4TB 2.5'' SSD SATA III Internal Solid State Drive lot
$13.99
Fanxiang SSD 512GB 1TB 2TB 4TB 2.5''SATA III Internal Solid State Hard Drive LOT
$19.99
M.2 NVMe SSD 128GB 256GB 512GB Single Notch with Windows Installed 10 / 11
$80.99
SAMSUNG SSD 870 EVO 2.5" SATA III Solid State Drive 2TB 1TB 250GB 500GB LOT
$172.15