Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Vintage Apple Newton MessagePad 120 (H0131)
$150.00
Apple | Macintosh Performa 200 | Vintage Personal Computer | Beige Casing
$199.95
VINTAGE 2004 Apple Silver APPLE PRODUCT PROFESSIONAL Pin in Original Container
$14.99
Vintage Apple Extended Keyboard II M3501 Mechanical Untested
$41.99
Vintage Apple Macintosh Computer Modem A9M0300
$65.00
Vintage Apple Computer Monitor
$45.90
Vintage Classic Apple Macintosh System Boot Install Disk Floppy/CD *Pick Version
$10.39
Vintage Apple Newton eMate 300 Laptop Computer 1997 H0208 Teal Blue Green Works
$189.99
MacEffects Chrome / Clear Mechanical Keyboard for Vintage Apple IIe Computers
$225.00
Vintage APPLE Quantum ProDrive ELS 3.5" SCSI 50-Pin HDD 81 MB TESTED
$35.95