Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
SONICWALL TZ270 Network Firewall With Power Cable *READY TO REGISTER*
$150.00
Fortinet FortiGate 60E Network Security Firewall No Power Cord
$56.00
1U BareMetal pfsense opnsense Router Firewall DNS Server 6x 10GB Ethernet Ports
$149.00
Palo Alto PA-220 Next-Gen Firewall 750-000128-00A w/ Power adapter
$50.00
Palo Alto PA-220 Next-Gen Firewall 750-000128-00A w/ Power adapter
$59.99
OPNsense six-port Gigabit router / firewall on Palo Alto ION 2000 hardware
$69.00
Cisco Meraki MX64W-HW Wireless 250Mbps 6x 1GB RJ-45 UNCLAIMED Firewall w/Adapter
$45.00
Ubiquiti Networks USG Unifi Security Gateway Router/Firewall
$75.00
Fortinet Fortigate FG-61E Firewall Network Security Appliance ATP Bundle 1 years
$299.99
Firewall pfSense 2.7.2 Release 8GB Memory - Dual NIC 1 GB - 256GB SSD
$103.77