Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Juniper SRX345-SYS-JB 8x GE RJ45 & 8x GE SFP Services Gateway w/ SRX-MP-LTE-AE
$175.00
Juniper SRX345 SRX345-SYS-JB 5 Gbps 8x GE RJ45 & 8x GE SFP Services Gateway
$124.99
Juniper EX4300-48T 48 Port Gigabit 4 QSFP 40G Dual PSU AFO w/EX-UM-4X4SFP Module
$99.00
Juniper QFX5200-32C-AFO QFX5200 32 Port QSFP 40/100G AFO Front to Back Airflow
$489.00
JUNIPER NETWORKS EX2200-C-12P-2G 12-PORT PoE+ COMPACT ETHERNET SWITCH
$60.00
Juniper EX4300-32F 32-Port 4x 10G Ethernet Switch - Dual AC Power - Tested
$119.95
Juniper EX2300-C 12 Port Compact Fanless Gigabit Switch 124W PoE+ EX2300-C-12P
$197.99
Juniper EX4100 48 Port Switch NEW Open Box EX4100-F-48T
$500.00
Juniper SRX-MP-LTE-AE B Mini MPIM Wireless Cellular Modem QTY Available Tested
$85.00
NEW / JUNIPER EX SERIES SWITCHING 8PORT SPF+/SFP Expansion Module NE
$292.50