Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Dell Memory SNP1CXP8C/16G AB371022 16GB 1Rx8 DDR4 SODIMM 3200MHz RAM
$64.95
Team T-FORCE VULCAN Z 16GB (2 x 8GB) 288-Pin PC RAM DDR4 3200 (PC4 25600) Intel
$35.99
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$14.85
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
A-Tech 16GB 2 x 8GB PC3-12800 Laptop SODIMM DDR3 1600 Memory RAM PC3L 16G DDR3L
$27.98
G.SKILL Trident Z RGB 16GB 2x 8GB 3200MHz DDR4 Desktop RAM F4-3200C16S-8GTZR
$38.99
Original Kingston 8GB 4GB 2GB DDR2 800Mhz PC2-6400 KVR800D2N6/2G Desktop Memory
$13.67
Crucial 16GB (2x 8GB) Kit DDR3 1600MHz PC3-12800 UDIMM Desktop 240-Pin CL11 RAM
$22.55
Corsair Vengeance 32GB 16GB 8GB DDR3 1600MHz 1866MHz 2133MHz 2400MHz Memory LOT
$79.99