Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
HP ProLiant MicroServer Gen8 Server Xeon E3-1220L 16GB RAM No HDD's
$299.00
HP Proliant MicroServer Gen 8 2.3GHz CPU 16GB RAM NO DRIVES/CADDIES INCLUDED
$179.99
HP ProLiant HSTNS-5151 Micro Server 8GB RAM No Drives/Key/Caddies *READ*
$94.99
HP ProLiant MicroServer Gen8 Server Xeon E3-1220L 8GB RAM No HDD's
$229.99
HPE ProLiant MicroServer Gen 10 Plus, Xeon E-2224, 16GB DDR4, 1TB M.2 NVMe SSD
$750.00
ProLiant MicroServer Gen8 Intel Xeon E3-1220L V2 2.3GHz CPU 8GB RAM
$170.00
HP ProLiant MicroServer Gen8 Server Intel Xeon E3-1220L v2 16GB DDR3 (4) 4TB HDs
$399.00
HP ProLiant N36L Micro Server 633724-001 AMD Athlon II Neo N36L - No HDDs
$82.07
HP ProLiant Microserver Micro Server HSTNS-5151 untested
$75.00
HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server P54644001
$849.99