Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Fortinet FortiGate 60F | 10 Gbps Firewall Network Security EXPIRED (FG-60F)- New
$226.79
Palo Alto PA-220 Next Generation Firewall Appliance w/ Power Adapter and Cord
$59.99
Palo Alto PA-820 Firewall Security Appliance
$120.00
Dell SonicWALL TZ500 Firewall 8-Port Network Security Appliance APL29-0B6
$40.00
Cisco ASA5506-K9 ASA 5506-X Network Security Firewall
$40.00
Fortinet FortiWiFi-60E Network Security Appliance - White
$38.40
Cisco Meraki MX84 Cloud Managed Security Firewall Appliance UNCLAIMED MX84-HW
$39.99
pfSense five-port Gigabit router/firewall on Barracuda F18b hardware
$79.00
Fortinet Fortigate FG-61E Firewall Network Security Appliance ATP Bundle 1 years
$263.99
Palo Alto Networks PA-850 Firewall VPN Gateway w/ Rack Ears and Dual PSU
$194.99