Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
SanDisk 2TB Ultra 3D NAND SSD, Internal Solid State Drive - SDSSDH3-2T00-G26
$149.99
Western Digital 250GB WD Blue SA510 SATA SSD, Internal M.2 2280 - WDS250G3B0B
$39.99
SanDisk 512GB Ultra microSD Memory Card for Chromebook - SDSQUAC-512G-GN6FA
$39.99
Dell 800GB SSD U.2 NVMe 2.5" PCIe Gen3 KWH83 MZWLL800HEHP-000D3 PM1725a
$71.99
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$14.99
Intel DC S3510 Series 120GB SSD 2.5" 6Gb/s SATA Solid State Drive SSDSC2BB120G6K
$9.99
Netac 1TB 2TB 512GB Internal SSD 2.5'' SATA III 6Gb/s Solid State Drive lot
$13.99
Fanxiang SSD 512GB 1TB 2TB 4TB 2.5'' SSD SATA III Internal Solid State Drive lot
$13.99
Fanxiang 256GB 512GB 1TB 2TB 4TB Internal SSD 2.5" SATA III 6GB/s for PC/MAC Lot
$188.09
Fanxiang 4TB 2TB 1TB SSD 550MB/s 2.5'' SATA III Internal Solid State Drive lot
$209.99