Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
HP 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A
$30.95
HP ProCurve 2530-24G J9776A 24 Port Gigabit Ethernet Managed Network Switch
$34.99
HP JG937A Flexnetwork 5130-48G PoE+ 48-Port Gigabit Network Switch
$65.95
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
NetGear ProSafe GS748T V4 48-Port Gigabit Smart Switch w/ Ears + Cord
$35.00
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$999.97
Cisco WS-C3560-48PS-S Catalyst 48-Port 10/100 Fast Ethernet Network Switch
$32.95