Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
OEM Dell 130W HA130PM130 DA130PM130 Laptop Power Adapter Charger 4.5mm 6TTY6 XPS
$26.99
OEM 130W USB-C Type-C Charger for Dell XPS 15 9500 9570 9575 17 9700 DA130PM170
$34.88
LOT - 59 OEM Dell AC Adapters HA65NM130 LA65NM130 LA90PM130 LA90PM170++ *TESTED*
$370.00
New OEM Dell Precision 3561 3570 3571 5470 5550 Laptop Charger Type-C
$24.51
Genuine OEM Dell 130W AC Adapter Charger Brick Large Tip 19.5V 6.7A
$4.97
OEM Dell Inspiron 11 13 14 15 17 3000 5000 7000 AC Adapter Charger 65W 4.5mm Tip
$10.99
NEW OEM 90W For Dell Thunderbolt 3 USB-C Type C Adapter Charger LA90PM210 LPS
$15.99
OEM DELL 65W AC Adapter Charger 7.4mm Latitude 7490 7480 E7440 E7450 E7470 E7270
$11.88
Genuine OEM 65W Dell PA-12 AC Adapter Charger For 928G4 LA65NS2-01 n4010 D531N
$13.99
Genuine 45W Power Adapter Charger for Dell DA45NM140 0KXTTW 4.5*3.0mm OEM
$16.99