Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco WS-C3750-48PS-S 48-Port Managed Gigabit Switch
$45.00
Cisco Catalyst 3850 48 PoE+ 48-Port Gigabit Managed Switch WS-C3850-48F-E
$219.99
Cisco Catalyst WS-C2960CPD-8PT-L 8-Port Ethernet Switch
$31.99
New Linksys SE3005 5-port Gigabit Ethernet Switch
$15.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$18.99
*NETGEAR PROSAFE (JGS524V2) 24-Port Gigabit Ethernet Switch *NO AC*
$29.99
TP-Link TL-SF1005D 5-Port 10/100Mbps Fast Ethernet Desktop Switch
$12.99
YuanLey 10 Port Gigabit PoE Switch With 8 Poe Unmanaged with 2 1000Mbps Uplink
$20.00
HP JG937A Flexnetwork 5130-48G PoE+ 48-Port Gigabit Network Switch
$67.95