-
Junior Member
registered user
7.7.1: Redirect to another display port
Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Vintage Commodor Computer Software Manual SysEx Analog 2 CMDOR CS..SX..A2 C
$100.00
The analog thing modern open source, educational, low-cost analog computer
$800.00
Vintage 60s Heathkit Ec-1 Educational Electronic Analog Computer W Extras Ec 1
$3000.00
NEW Aquarius+ Mini 8Bit Retro Computer System - Assembled PCB ONLY
$99.00
IBM Modem Saver Phone Line Tester
$7.99
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
FULLY RECAPPED MACINTOSH CLASSIC II 2 VINTAGE MAC APPLE COMPUTER NEW BATT WORKS
$899.00
Macintosh Plus, BlueSCSI, OS 6.x, 4 mb memory - recapped, tested, working.
$715.00
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
Macintosh Classic/Classic II Analog Board Computer 630-0395 New
$278.00