Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
$168.00
1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 240GB SSD 2x 10GBE
$259.00
1U BareMetal pfsense opnsense Router Firewall DNS Server 6x 10GB Ethernet Ports
$149.00
Supermicro 1U Server X9SRI-F Xeon E5-2640 v2 2.5Ghz 16-Cores / 64GB / No HDD
$149.99
HP Proliant MicroServer (Model: HSTNS-5151) NO HARD DRIVES-Power Tested,
$99.99
SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount
$202.49
HP ProLiant MicroServer Gen10 Plus - 16GB RAM No HDD
$500.00
SuperMicro SuperServer 5018A-FTN4 505-2 Intel Atom @ 2.4GHz 8GB w/ Ears
$174.99
HPE ProLiant v2 Ultra Micro Tower Server Pentium Gold G6405 16GB RAM P69102005
$696.73
SuperMicro SuperServer 5038MR-H8TRF Blade w/X10SRD-F Board E5-2630v3 Proc 128GB
$263.96