Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Vintage DEC/CLEARPOINT INC. -QRAM-2 SAB-1 1MB Q-BUS MEMORY MSV11-QA (B2)
$129.99
*NEW UNOPENED* Vintage DEC LB-5923 Keyboard
$50.00
Vintage DEC/The Redac mini cabinet front panel Digital Equipment Corp. 19"
$269.99
Vintage DEC Digital Equipment Corp PDP 11/40 G114 16K SENSE/INHIBIT (B10)
$269.99
DEC PDP 8/M PDP 8M / 4 avail / Vintage Digital Equipment Corp /Also DEC PDP 12
$5775.00
DEC DIGITAL Equipment Corp VT220-D2 Vintage CRT Terminal
$215.00
Vintage DEC Digital 018L 19-17043-02 DIP40 Gold Ceramic De/Serializer IC Chip
$7.95
Vintage DEC R82-HDA Industrial Hard Drive
$64.95
Vintage Digital Equipment DEC Medical Systems Front Control Panel Bezel
$499.00
VINTAGE DEC Digital RK11-D DISK CONTROL M7255 PDP 11 (B1)
$129.99