Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
DELL PowerEdge R730XD Server 2x E5-2697v4 2.3GHz =36 Cores 64GB H730 4xRJ45
$407.00
DELL PowerEdge R630 8SFF Server 2x E5-2650v4 2.2GHz =24 Cores 32GB H730 4xRJ45
$240.00
Dell PowerEdge R430 3.5 1U 2x E5-2690 v3 2.6ghz 24-Cores 256gb 4x Trays 2x 550w
$359.99
DELL PowerEdge R630 8SFF Server 2x E5-2680v3 2.5GHz =24 Cores 32GB H730 4xRJ45
$230.00
Dell PowerEdge R730XD 28 Core Server 2X Xeon E5-2680 V4 H730 128GB RAM No HDD
$389.99
Dell PowerEdge R620 Server 2x E5-2660 v2 2.2GHz 20 Cores 256GB RAM 1x 480GB SSD
$139.99
HP Proliant DL360 G9 2x2.6GHz Intel 14 Core Xeon E5-2697v3, 32GB RAM, NO HDD
$139.99
Dell PowerEdge R710 2.5" 2U Server 2x X5670 2.93GHZ 12-Core 128gb 2x 1TB SAS
$114.99
Cisco UCS C220 M3 1U 2x 6-Core Xeon E5-2620 2.0GHz / 64GB RAM / No HDD
$89.99
1U BareMetal pfsense opnsense Router Firewall DNS Server 6x 10GB Ethernet Ports
$149.00