Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Seagate 10TB 7200RPM 12Gbps 3.5in SAS Hard Drive ST10000NM096
$79.99
Seagate Exos 7E10 ST2000NM000B 2TB 7200RPM SATA 6.0Gb/s 3.5" Internal Hard Drive
$29.99
Dell ST2000NX0403 2T SATA 2.5 inch 7.2K CK3MN server hard drive
$45.00
HGST Ultrastar HE10 HUH721010ALE600 10TB SATA 6Gb/s 7200RPM 3.5" Enterprise HDD
$69.99
HGST Ultrastar DC HC520 12TB SATA 6Gb 256MB 3.5" Enterprise HDD- HUH721212ALE601
$89.99
Seagate ST12000NM0127 12TB 256MB 7200RPM 3.5" SATA 6.0Gb/s Enterprise Hard Drive
$93.88
Seagate ST12000NM0127 12TB SATA 6Gb/s 256MB 7200RPM 3.5" Enterprise Hard Drive
$99.99
SEAGATE ST4000NM0023 HARD DRIVE 3.5" SAS 4TB HDD
$16.99
Western Digital WD10JUCT 1TB 2.5" SATA 3Gb/s 5400 RPM 16MB Laptop Hard Drive
$17.98
HGST 0F27352 10TB 3.5" SAS 7200 RPM 12Gb/s Hard Drive 100% #73 v
$65.00