Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$419.99
Cisco SG95-16 16-Port Gigabit Switch SG95-16-KR
$47.00
Cisco Nexus N55-D160L3-V2 2 Ports Daughter Card Expansion Module 1 Year Warranty
$395.00
Cisco WS-C3750-48PS-S 48-Port Managed Gigabit Switch
$45.00
QSFP-40G-SR-BD Cisco 40GBASE-SR-BiDi, duplex MMF QSFP+ Modules 10-2945-02
$27.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco C3850-NM-4-10G 4 Port Network Expansion Module
$200.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$48.99
Cisco Nexus N3K-C3172PQ-XL 48P 10GbE SFP+ 4P QSFP+ Switch N3K-C3172PQ-XL-F
$229.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$79.00