Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Western Digital 1TB Caviar WD1002FBYS Enterprise SATA Hard Disk Drives
$24.99
832514-B21 HPE 1TB SAS 12Gb/s 7.2K SFF SC HDD 832984-001
$129.00
Western Digital 1TB WD Blue SA510 SATA SSD Internal 2.5”/7mm Cased - WDS100T3B0A
$89.99
### MZ-7KE1T0 Samsung 850 Pro Series 1TB 2.5 inch SATA3 SSD ###
$105.00
2 PACK Seagate ST1000LM035 Mobile HDD 1TB 2.5" SATA III Laptop Hard Drive
$27.25
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$19.99
Samsung - Geek Squad Certified Refurbished 870 EVO 1TB SATA Solid State Drive
$67.99
Netac 1TB 2TB 512GB Internal SSD 2.5'' SATA III 6Gb/s Solid State Drive lot
$13.99
Seagate ST1000LM035 Mobile HDD 1TB 2.5" SATA III Laptop Hard Drive 0 Relocated
$15.49
1TB 2TB Type C USB 3.0 Flash Drive Thumb Drive Memory Stick for PC Laptop New
$9.99