Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
The analog thing modern open source, educational, low-cost analog computer
$800.00
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$229.00
Apple Macintosh SE/30 M5119 Computer 8MB RAM Recapped Working *See Description*
$475.00
IBM Modem Saver Phone Line Tester
$7.99
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
NEW Aquarius+ Mini 8Bit Retro Computer System - Assembled PCB ONLY
$99.00
Soviet Union motherboard analog computer ZX Spectrum USSR
$97.00
ACASIS PCIE Capture Card HDMI 1.4 1080P60HZ PCIE 2.0 X4 20Gbps for Video Capture
$248.99
Sony Trinitron CPD-1304 9 PIN Analog Vintage CRT Monitor - Great for Retro PC
$475.30