Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco ASA 5520 Adaptive Security Appliance
$42.56
Cisco ASA5525-K9 ASA 5525-X Security/Firewall Appliance 1 Year Warranty
$138.00
NetFu Firewall 1U, Intel CPU, 8 x Gigabit, SFP, w/ pfSense, Others, NEW OPTIONS
$541.85
Ubiquiti Networks USG Unifi Security Gateway Router/Firewall
$29.95
Fortinet Fortiwifi 60D FWF-60D Security Appliance Firewall Wifi VPN
$29.99
Fortinet Fortigate-60E Network Security Firewall FG-60E White
$71.99
OPNsense six-port Gigabit router/firewall on Lanner FW-7535 hardware
$69.00
Fortinet Fortiwifi 60D FG-60D Security Appliance Firewall / VPN w/ AC Adapter
$34.97
Sophos SG-115 Rev 2 UTM Firewall Security Appliance 4-Port w/Power Adapter
$65.00
Check Point 1450 Network Security/Firewall Appliance CPAP-SG1450-NGTP
$60.00